![]() ![]() Put some of the dielectric grease on the coil pack posts before you put the plug wires on.Įasy job, you can have it all done in 30 to 45 min. If there is corrosion on the posts, you may have corrosion on the base of the coils and the engine surface that they mount on. I changed the oil, filter, plus, wires, h20 pump, t-stat, coolant and all coolant hoses, tranny fluid and filter. Either an 8 or 10 MM socket on the bolts and they come right off. I recently bought this wonderful sc2 with 125k miles 1.9 l dohc. The rod bolts are torque to yield and one time use except that they are no longer available and the used ones can be re-torqued to 31-33 ft-lb. If you have gone this far and you see corrosion on the coil pack posts, you MAY wish to go ahead and remove the coil packs themselves. Re: 1999 SL2 1.9 DOHC engine specs The torque specs are the same for the 99 and 91-98 as far as the engine goes with the exception of the rod bolts. IF you note any corrosion on the coil pack posts, you should clean this off with either some scotch brite, sand paper, small wire brush or something of that nature. But all you need is an 8 MM socket, I believe, to remove it and then the wires just pull off the packs. However I believe your 97 will have a hold down device on the wires at the coil packs. You will see them when you follow the wires down to the front of the engine. Like posted before, there is no distributor. Most standard aftermarket wires will work fine. This will help keep moisture out and make it easier to get the wires off the next time.Īs for the wires. Use a dielectric grease on the plug wire boots. ![]() Throttle body upgrades for 1.9l dohc engines Parting out green 1997 SL2 sl2 seat stuff. Some anti-seize compounds are conductive so make sure you do not get any around the plug electrode. saturn vue redline for sale Aquamarine 1993 SL2 for sale. Put a SMALL dab of anti seize on the spark plug threads. The torque is not 20 Nm, (newton meters), it is 20 Ft Lbs, Do this if at all possible with the engine COLD. I've seen references to a gap of 0.40 and torque of 20 Nm. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |